lvfert.blogg.se

Nissan electric forklift
Nissan electric forklift













  1. NISSAN ELECTRIC FORKLIFT FULL
  2. NISSAN ELECTRIC FORKLIFT CODE

Possible causes: (1) radiator dirty (2) pushing pallets (3) inching pedal not adjusted properly.Į- 33 Engine Coolant over heat (step 2). Coolant temp sensor has seen 230° or higher. Check for corrosion at ETC relay, or water in the relay box.Į- 32 Engine Coolant over heat (step 1).

NISSAN ELECTRIC FORKLIFT CODE

If code follows to the known good truck, replace the ECM.Į- 31 Electronic Throttle Control actuator circuit malfunction. (2) Loose connection (reseat ECM connectors and perform key learns.) (3) Swap ECM with one on a known good truck. Verify ECM: (1) Check power and ground at ECM. If truck has an emergency stop switch, check its function and connections. Check Main “C” relay.Į- 30 ECM circuit malfunction. Should be “no start”, bad sensor.Į- 29 LPG Fuel Cut circuit malfunction. (3) sensor/connections.Į- 28 Camshaft Position sensor. then - Check: (1) spark plugs, (2) coil packs - one at a time, then as a set. Is it a non-extended crank? But, runs rough, is missing, etc. Is it an extended crank? If yes, verify fuel pressure is correct. Heater circuit signal malfunction.Į- 27 Crankshaft Position sensor. Sensor circuit signal malfunction.Į- 26 02 sensor heater. Perform the two “key learns”.Į- 25 02 sensor. Push and pull individual wires.Į- 24 Accelerator sensor. Check for corrosion at bottom of ETC relay box. Verify 5 volt power supply at the throttle body from ECM. (This is the two-wire sensor to ECM.)Į- 23 Throttle sensor. Check for broken wire, loose connection.Į- 22 Water Temperature sensor. Check for corrosion on Maintenance ( OBD-II ) connector.Į- 21 Mass Air Flow sensor. Check for poor or no connection at VCM, ECM and M/P.

nissan electric forklift

Check power and ground at VCM, ECM and M/P. Please call Mister Mechanic 90 ext 2 Monday to Friday 8 am to 5 pm.E- 03, E- 04, E- 07 Can bus malfunction. If this is not the correct unit for your requirement, please let us know because we always refurbish machines of all kinds of forklifts, reach trucks, order pickers, hybrid pallet trucks and brand new forklifts in all capacities. If you are looking for a good electric forklift in 5000 lb capacity, considering the battery condition and brand new tires, this would be a good choice. If you are further away, please let us know we can get you the best transport cost. We can ship this machine locally for $100+HST (GTA). We could break it up and sell the parts and tires for almost as much as we are asking, but we would prefer to sell it as an operating unit to a small company, that is just starting out.

nissan electric forklift

However it drives well, runs well and lifts really well. We will sell this forklift on ‘as is’ basis only, so please do not ask us to certify it. We will provide the battery charger as required for either option.

nissan electric forklift

It has the LED front lamp and the blue laser light at the back with back-up alarm. You can see the picture of it, how clean the battery is. The 32” larger battery is really in great condition which will give you at least 3 hours operating time. It has the side-shift and it is equipped with class 2-42” forks.

NISSAN ELECTRIC FORKLIFT FULL

The forklift has a 3 stage full free lift mast which will go to a maximum of 181” and the low is 86”. The battery is really good in condition and it has 4 new white non marking tires on it. It is a 1997 model unit with good hours but however the truck is in fine condition. Available for sale is a Nissan 5000 lb cap machine in good condition.















Nissan electric forklift